To Operate The Product - Husqvarna DM400 Manuel D'utilisation

2. To set the operation speed, turn the drill spindle and
at the same time move the gear selector. Set the
gear selector in the correct position for the operation.
3. Make sure that the water system is open.
1188 - 006 - 03.02.2020
4. Set the ON/OFF switch to "1".

To operate the product

WARNING: If the PRCD engages, remove
the drill bit from the hole before you push
"RESET".
WARNING: Dangerous accidents can occur
if the concrete core stays in the drill bit when
you remove the drill bit from the hole.
CAUTION: Make sure that no objects hit the
drill bit.
CAUTION: Do not use more force than
necessary. This only makes the operation
slow and causes overload to the motor.
1. Start the motor. Refer to
page 12 .
2. Let the motor speed increase to the maximum speed
before the drill bit touches the surface.
3. Push the drill bit into the surface with the feed lever.
4. If you drill through iron reinforcements, use more
initial pressure and a lower gear than if there were
no iron reinforcements.
5. Use very small pressure initially to keep the drill bit in
correct position.
6. During operation, make sure that the water removes
all waste material from the drill hole. Adjust the water
pressure if it is necessary.
7. Stop the motor. Refer to
14 .
To start the product on
To stop the product on page
13