Intended Use; Product Overview; Symbols On The Product; Product Liability - Husqvarna DM 200 Manuel D'utilisation

Masquer les pouces Voir aussi pour DM 200:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Some types of this product are connected via the
embedded Husqvarna Fleet Services
the Bluetooth Low Energy (BLE) function. For more
information regarding how to use it, refer to
embedded connectivity on page 11 . For information
about the BLE technology radio spectrum, refer to
Embedded connectivity on page 17 . For compliance
reservations regarding Husqvarna Fleet Services
To use embedded connectivity on page 11 .
refer to
Compliance reservations
Note: Changes or modifications made to this equipment
not expressly approved by HUSQVARNA may void the
equipment's compliance with FCC regulations, and limit
the user's authority to operate the equipment.
Note: This device complies with Part 15 of the FCC
Rules and with Industry Canada licence-exempt RSS
standard(s).

Product overview

(Fig. 1)
1. Water connector
2. Drill spindle
3. Clamp ring
4. Mounting thread for water/dust extractor connector
5. Dust extractor connector
6. Gearbox
7. Gear selector
8. Auxiliary handle
9. Motor
10. Inspection cover
11. Electronics box
12. Spirit level
13. Power switch
14. Main handle
15. PRCD
Note: In this manual we use the term PRCD for
PRCD and GFCI.
16. Adapter coupling
17. Wrenches
®
18. Gardena
male coupling with water valve
19. Operator's manual

Symbols on the product

(Fig. 2)
WARNING! This product can be dangerous
and cause serious injury or death to the
6
sensor that has
To use
,
Operation is subject to the following two conditions:
this device may not cause harmful interference
this device must accept any interference received,
including interference that may cause undesired
operation

Intended use

The product is used to drill concrete, rock, asphalt and
masonry. All other use is incorrect.
The product is used in industrial operations by operators
with experience.
operator or others. Be careful and use the
product correctly.
(Fig. 3)
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
(Fig. 4)
Always use approved personal protective
equipment. Refer to
equipment on page 9 .
(Fig. 5)
Environmental mark.The product or package
of the product is not domestic waste.
Recycle it at an approved disposal location
for electrical and electronic equipment.
Note: Other symbols/decals on the product refer to
special certification requirements for some markets.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
the product is incorrectly repaired.
the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
the product is not repaired at an approved service
center or by an approved authority.
Personal protective
1416 - 006 - 29.01.2021

Publicité

Table des Matières
loading

Table des Matières