CarKids ISOFIX 0 Mode D'emploi page 19

5.2 Group I (9 to 18kg) lnstall Forward Facing
5.2.1 Ensure the seat is ready to install in forward facing (Group I), pull the
backrest reclining handle to adjust to angle to position 1, 2 or 3,
then release the handle.
5.2.2 lt is necessary swivel the seat 180° to place the seat in the direction
of travel. Release the backrest rotating handle when the seat is in the
desired position.
5.2.3 Locate the ISOFIX arms in the base of the seat.
5.2.4 Place the child safety seat in the back seat of the vehicle facing in the
direction of travel.
5.2.5 Hold the child seat with both hands and insert the two ISOFIX arms firmly
into the vehicle's ISOFIX anchoring points until they fasten with a click on
both sides. The red button will change to green on both sides.
5.2.6 Shake the seat to check that it is correctly anchored to the vehicle's
ISOFIX points.
5.2.7 Pull out the Top Tether and press the tether strap release button to
extend the strap until it is long enough to connect it to the Top Tether
anchorage point in the vehicle. lf the Top Tether is tightened favorably
and correctly, the button will change to green.
5.2.8 Make sure the 5-point harness of safety seat has been correctly installed
(see section 4.1)
5.2.9 Open the buckle, put the shoulder harness to the sides, then put the child
into the safety seat. Please check if shoulder harness height is equal to
your child's shoulder height, press the adjusting device and pull the
shoulder harness to be loose, then press the headrest handle to adjust the
shoulder harness to the suitable position.
5.2.10 Slide the two tongues together into the buckle. The buckle will not
function well till you hear "click". Adjust the child restraint belt to make
sure the lap belt is well restrained the child's pelvis. Then tighten the
shoulder straps by pulling the adjustable strap at the front of the
bottom cushion.
5.2.11 lf you want to release your child from the safety seat, press the adjusting
device at the front of the bottom, at the same time pull the shoulder
straps. Then press the red button on the buckle, place the shoulder straps
at the side and let your child out.
5.2.12 The insertion guides facilitate the installation of the safety seat with the
aid of the ISOFIX securing points and prevents damage to the upholstery.
When not in use they should be removed and stored in a safe place. In
vehicles with a reclining back the insertion guides should be removed
before the seat is reclined. Problems that may arise are generally the
result of accumulation of dirt or foreign bodies in the insertion guides and
the clasps. To solve this type of problem simply clean the part in question.
19
EN