CarKids ISOFIX 0 Mode D'emploi page 15

4.7 Adjust the length of harness
In order to protect your child much better, after fixing him/her in the child
restraint system and lock the buckle, you should tighten the harness so they are
snug and flat against the child's body, they should never be twisted or loose.
4.7.1 To tighten the harness, pull the shoulder belt upwards to remove the slack
from the lap sections of the harness, at the same time to pull the adjuster
crotch belt coming from the lock by your other hand.
4.7.2 To lengthen the harness, press the button on lock between the child's
two legs, then pull the two shoulder belt simultaneously in your direction,
please note while you are doing this hold the harness, not the harness cover.
CAUTION! Check that the harness straps are not twisted and that they have been
correctly inserted in the belt slots on the cover.
4.8 Adjusting the headrest in an installation with a 5 point harness. Group 0+ and I.
4.8.1 A correctly adjusted harness ensures that the diagonal seat belt section
is positioned, and gives your child the optimal protection.
4.8.2 The harness must be adjusted to that there is a space two fingers wide
between the harness and your child's body.
4.8.3 A correctly adjusted headrest ensures optimal protection for your child in
the safety seat: shoulder belts are at the same level as your child's shoulders.
15
EN