Yamaha A-S500 Mode D'emploi page 19

Amplificateur intégré
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problems
The PURE DIRECT switch is turned on.
Using the BASS,
TREBLE, BALANCE
and LOUDNESS
controls does not
affect the tonal quality.
■ Universal Dock for iPod and Wireless System for iPod
Problems
There is a problem with the signal path
No sound.
from your iPhone/iPod to the unit.
You cannot operate
the iPhone/iPod.
The iPhone/iPod being used is not
supported by the unit.
The wireless connection is poor.
When using a
Wireless System for
iPod:
Sound frequently cuts
out.
Noise is heard.
This unit is not turned on.
When using the
Universal Dock for
The iPhone/iPod is not connected
iPod:
securely.
Your iPhone/iPod is
not being charged
even though it is
connected to the
Universal Dock for
iPod.
This unit is not turned on.
When using the
Wireless System for
The YID-W10 transmitter is not stationed
iPod:
securely in the YID-W10 receiver.
Your iPhone/iPod is
not being charged
even though the YID-
W10 transmitter
connected to your
iPhone/iPod is
stationed in the YID-
W10 receiver.
Possible Causes
Possible Causes
Solutions
The PURE DIRECT switch must be turned off to use
those controls.
Solutions
Turn off the unit and reconnect the Universal Dock
for iPod or the Wireless System for iPod to the
DOCK jack of the unit.
Remove your iPhone/iPod from the Universal Dock
for iPod or the Wireless System for iPod and then
place it back in the dock.
Connect an iPhone/iPod supported by the unit.
Place the YID-W10 receiver as far away from this
unit as possible.
Turn on this unit or set it to standby mode.
Connect the iPhone/iPod securely to the Universal
Dock for iPod.
Turn on this unit or set it to standby mode.
Station the YID-W10 transmitter connected to your
iPhone/iPod securely in the YID-W10 receiver.
TROUBLESHOOTING
Refer to
page
8
Refer to
page
10
10
10
10
2
10
2
10
15
En

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

A-s300

Table des Matières