Makita XCV03 Manuel D'instruction page 7

1 1
015674
Press the check button to make the battery
indicators show the remaining battery
capacities. The
correspond to each battery.
Remaining battery capacity indication
Battery indicator status
Blinking
On Off
015527
Indicating the remaining battery
capacity
(Only for battery cartridges with "B" at the
end of the model number.)
2
015676
Press the check button on the battery cartridge
to indicate the remaining battery capacity. The
indicator lamps light up for few seconds.
2 2
battery indicators
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
1. Indicator lamps
2. Check button
1
Indicator lamps
Lighted
015658
NOTE:
Depending on the conditions of use and
•
the ambient temperature, the indication
may differ slightly from the actual capacity.
Switch action
2
3
015529
To start the cleaner:
1. Set the stand-by switch to the "I" side.
The cleaner gets into stand-by state.
2. Press the power button.
To make the cleaner get into stand-by
mode, press the power button again.
To turn off the cleaner, set the stand-by
switch to the "O" side.
The suction
according to your work need.
Suction power can be increased by turning
the suction force adjusting knob from the
symbol to the
NOTICE:
Always set the stand-by switch to the
•
"O" side when not using the cleaner for
long time. The cleaner consumes
power during stand-by state.
7
Off Blinking
malfunctioned.
1. Stand-by switch
2. Power button
3. Suction force
adjusting knob
1
power can be
symbol.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
adjusted