Makita XCV03 Manuel D'instruction page 11

1. Holder plate
2. Polyethylene bag
015542
Spread the polyethylene bag in the tank.
Insert it between the holder plate and the
tank, and pull it to the hose inlet.
Spread the bag around the top of the tank
so that the prefilter edge can catch and
hold the bag securely.
NOTE:
A polyethylene bag available on the
•
market can be used. 0.04 mm or
thicker one is recommended.
Too much dust will tear the bag easily,
•
so do not collect the dust more than
the half of the bag capacity.
Emptying the polyethylene bag
WARNING:
Always make sure that the cleaner is
•
switched off and unplugged before
emptying the polyethylene bag. Failure
to do so may cause an electric shock
and serious personal injury.
CAUTION:
Do not apply a great impact on the float
•
cage and tank. Applying a great impact
may cause deformation and damage to
the parts.
Empty the tank at least once a day
•
although this depends on picked-up
dust volume in the tank. Or, the suction
force will weaken and the motor may
be broken.
Do not grab the hook when emptying
•
the tank. Grabbing the hook may cause
the hook to break.
Unhook and lift up the tank cover.
1
2
015544
Shake off the dust from the cloth filter /
powder filter and then take the polyethylene
bag out of the tank.
NOTE:
Take the polyethylene bag carefully out
•
of the tank so that the polyethylene bag
cannot be caught and torn by the
protrusion
emptying it.
Empty the polyethylene bag before it
•
becomes full. Too much dust in the
tank may cause the polyethylene bag
to be torn.
Installing the tool box
015537
1. Release the lock of the battery cover,
and open the battery cover.
2. Set the rails on the tool box along the
grooves on the housing.
3. Close the battery cover and apply the
lock.
015538
The tool box is convenient for carrying
batteries, extension code, pipe, or cuffs.
11
inside the tank when