Makita XCV03 Manuel D'instruction page 6

Hold the cleaner and the battery
•
cartridge firmly when installing or
removing battery cartridge. Failure to
hold the cleaner and the battery
cartridge firmly may cause them to slip
off your hands and result in damage to
the cleaner and battery cartridge and a
personal injury.
Be careful not to pinch your fingers
•
when opening or closing the battery
cover. Failure to do so may cause
personal injury.
2
1
015530
To install the battery cartridge, release the
lock first, and open the battery cover. And
then, insert the battery cartridge.
1
015531
Align the tongue on the battery cartridge
with the groove in the housing and slip it
into place. Insert it all the way until it locks
in place with a little click. Then lock the
battery cover.
To remove the battery cartridge, slide it
from the tool while sliding the button on the
front of the cartridge.
NOTICE:
Remove the plug of the cleaner from
•
the extension cord when using the
cleaner with the batteries.
CAUTION:
Always install the battery cartridge fully
•
in place. If not, it may accidentally fall
out of the tool, causing injury to you or
someone around you.
1. Lock
2. Battery cover
1. Battery
cartridge
6
Do not install the battery cartridge
•
forcibly. If the cartridge does not slide
in easily, it is not being inserted
correctly.
NOTE:
The cleaner does not work with only
•
one battery cartridge.
Tool / battery protection system
The tool is equipped with a tool/battery
protection system.
automatically cuts off power to the motor to
extend tool and battery life.
The tool will automatically stop during
operation if the tool or battery is placed
under one of the following conditions. In
some conditions, the indicators light up.
Overload protection
If the tool is overloaded, the tool stops
automatically. In this situation, turn the tool
off and stop the application that caused the
tool to become overloaded. Then turn the
tool on to restart.
Overheat protection for tool
On
015485
When the tool is overheated, the tool stops
automatically, and the battery indicator
blink about 60 seconds. In this situation, let
the tool cool down before turning the tool
on again.
Overdischarge protection
When the battery capacity becomes low,
the tool stops automatically. If the product
does not operate even when the switches
are operated, remove the batteries from the
tool and charge the batteries.
Remaining battery capacity
indication
1 2
1
015550
This system
Blinking
1. Check button