Operation Instructions; Safe Affairs - HOLZMANN MASCHINEN MTY 8-70 Mode D'emploi

10.1

Operation instructions

 The machine is specially designed for hard alloy grinding blade, which is fit for grinding all
kinds of hard alloy saw blades.
 Its fascia can support the teeth of saw blade and other parts in order to prevent jumping and
improve grinding quality.
 The positioning pin can be adjusted to the best position in order to ensure the conformability
of grinding blade.
 Slip board can rotate horizontally, which can ensure the primary grinding angle or change it.
 The rotation table on the fascia can adjust the process angle of grinding blade.
 If the center axle is far away from the direction of grinding blade, and when the diameter of
grinding saw blade and saw teeth are bigger, the angle of saw blade is smaller, the grinding
blade and saw blade can be reversed 180
 Slip block, centre axle, limited screw is installed on the rotation table, which is fit for operation
and ensure the diameter from grinding blade to the center.
 20 rotation structure is installed on the grinding head, which can meet grinding for bevel saw
teeth.
 The diamond wheel can be dry-grinded.
 First loose the fascia, then adjust the angle of grinding blade and fasten.
 Adjustment of center axle
 Rotate the center axle to the
grinding blade when grinding
small saw; otherwise away from
the grinding blade.
 Push the center axle to the right
 Install the saw blade, rotate the
wheel and decide the position of
grinding surface of saw teeth.
 Rotate the rotation
ensure the angle if grinding face
of saw teeth.
 Rotate the rotation
order to ensure process angle of
grinding blade .The cross angle
between the grinding surface
and work.
 Adjustment of positioning assembly. Adjust the saw blade to the best grinding condition, rotate
the positioning frame and fascia, adjust positioning pin to the more proper base of saw teeth
and leave gap of grinding quantity, the fasten the fixed screw.
 Adjust the center axle to the same gap of grinding quantity to the right.
 After all the parts are fastened, the saw blade supported with hand will be grinded.
10.2

Safe affairs

 Meet standard presure, grounding earthing well.
 The machine must be put on the dry, non-corrosive, steady and level position.
 First loose fascia and then adjust the angle of ginded blade.
 Fasten all the fastened parts before the machine is operated.
 The machine doesn't work until it works usually.
 Cut off the power when work is over.
 Change the machine without permition and it will cause the bad result
HOLZMANN MASCHINEN GmbH
table to
table in
www.holzmann-maschinen.at
and adjust the table to a proper angle.
OPERATION
21
MTY 8-70