Playback; Playing A Source; Using The Sleep Timer - Yamaha R-S202 Mode D'emploi

Masquer les pouces Voir aussi pour R-S202:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Playing a source

SLEEP
LINE 1
CD
TUNING
PRESET
TREBLE
TREBLE –/+
BASS
BASS –/+
BALANCE L/R
MENU
1
Press A (power) to turn on this unit.
2
Press one of the Input selector buttons to
select the desired input source.
3
Press SPEAKERS A and/or SPEAKERS B to
select the desired speaker(s).
y
• When one set of speakers is connected using bi-wire
connections, or when using two sets of speakers
simultaneously (A and B), make sure SP A and SP B are
displayed on the front panel display.
• When listening with headphones, turn off the speakers.
4
Play the source.
5
Press VOLUME +/– to adjust the sound
output level.
y
You can adjust the tonal quality by using BASS –/+ and
TREBLE –/+, and the left/right sound balance of speakers
by using BALANCE L/R (see page 6).
12
En

PLAYBACK

A (power)
LINE 2
LINE 3
Input selector
buttons
TUNER
BAND
MEMORY
INFO
A
A
SPEAKERS A/B
SPEAKERS
B
B
BALANCE
R
R
BLUETOOTH
ENTER
DIMMER
MUTE
VOLUME
VOLUME +/–
6
When finished listening, press A (power) to
set this unit to standby mode.
Press A (power) to turn this unit on again.
y
• You can also use the buttons or knobs on the front panel if
they have the same or similar names as those on the
remote control.
• For recording, see page 5.

Using the sleep timer

Use this feature to automatically set this unit to standby
mode after a certain amount of time. The sleep timer is
useful when you are going to sleep while this unit is
playing or recording a source.
SLEEP
SLEEP
LINE 1
CD
Press SLEEP repeatedly to set the time duration
until the unit enters standby mode.
Each time you press SLEEP, the time duration indicated
on the front panel display changes cyclically as shown
below.
120 min
off
30 min
The SLEEP indicator blinks while setting the amount of
time for the sleep timer.
If the sleep timer is set, the SLEEP indicator on the front
panel display lights up.
y
To cancel the sleep timer, do one of the following:
– Select "SLEEP OFF".
– Press A (power) to set this unit to standby mode.
A (power)
LINE 2
LINE 3
TUNER
BAND
90 min
60 min

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

R-s202d

Table des Matières