On/Off Button; Menu Button; Leak Button - WIKA CPC2000 Mode D'emploi

4. Design and function
In control mode: Starts the leak measurement, otherwise without function

During the control process → Vent otherwise, selects SETUP

Increase set point by x %

Increase set point to 100 %


ON/OFF button


Decrease set point by x %

Set set point to 0 %

Zero point adjustment

Pressure connections

The front screen of the display, behind the membrane, is made from
glass. If there is any possibility of the window breaking during operation
(including damage to the front membrane), all personnel in the vicinity of
the instrument must wear eye protection before and during its use.
4.5.1 On/Off button
Button to turn the instrument on and off.

4.5.2 Menu button

With this button the SETUP menu can be accessed, and there the settings
for each operating mode can be made. When the CTRL mode is used, you
will find that the device is left in VENT mode on leaving the SETUP menu.
The SETUP menu items are made up of six submenu items. For a detailed description of
these items, see chapter 6.5 "SETUP settings (SETUP)".

4.5.3 LEAK button

With the LEAK button, a device connected to the controller can be tested
for leaks. (This feature is only available in CONTROL mode.)
WIKA operating instructions, model CPC2000
EN
15