Facom DB1.RFID Notice Originale page 21

 At each opening/closing followed with a movement of the bag, an automatic scan is
launched. Do not open the bag during a scan: in this case, it stops immediately.
 If no tool is missing, the following message appears:
 If an anomaly is detected: tool(s) missing or tool(s) not in the reference list, the
following message appears:
 The user can then run a new scan to check there is no error (see 'Characteristics,
general information & Warnings' section), or list the missing tool(s). The selection is
made using the arrow button.
'xx' designates the number of problem(s) detected
 By validating 'Detail', 2 options are possible: tool(s) missing or tool(s) unknown:
• If one or several tool(s) are missing, it is possible to list the missing tool(s) on the
screen using the arrow button.
NU-DB1.RFID_0216.indd 21
21
3/25/2016 9:14:14 AM