Motion Detect - RC Logger 89050RC Instructions D'utilisation

17. moTIon deTeCT

Motion detection reacts to changes in the camera image.
Follow these steps to activate motion detection:
1. Turn the monitor on and connect a camera.
2. Switch the video switch (13) into position
Start Motion Detect" is displayed.
3. Press and hold the button
activate the motion detection. "Motion Detecting.." is
displayed.
4. As soon as motion is detected video will be recorded.
"REC" (C) and the recording time (I) will be displayed.
When no motion is present recording is stopped after a
short period (approx. 10 seconds) and the video is saved.
> To toggle muting of audio, press button m. This does not
affect headphone output.
> Press button to save recording and exit motion detection.
> Video size can be controlled via video segment sizes. See
section "Sub-1 Video Segment Size" on page 17 for more
information.
. "Press Rec to
for approx. 3 seconds to
Make sure the wireless signal is sufficiently strong,
stable and no interferences are present. Otherwise
motion detection may be triggered unintentionally.
overwrite mode
See section "Sub-1 Overwrite" on page 17 for more
information. Whenever a video is saved, previously saved clips
are overwritten by the latest recording, once storage space is
full.
21