Placing The Product; Charging The Battery - RC Logger 89050RC Instructions D'utilisation

9. PlaCIng The ProduCT

> The monitor shall be used in a dry environment. Any form of
liquid must be strictly avoided.
> Make sure you hold the monitor firmly in your hand at all
times.
> You may place the monitor on a stable surface by flipping
out the stand (9) at the back to the monitor. Once you place
the monitor, it will rest at an angle for comfortable viewing.
The monitor gets warm during operation. Be careful
not to place the monitor on any surface sensitive to
heat.
Tripod
The standard DIN tripod attachment (11) on the holder (10)
allows you to mount the monitor onto a standard tripod
attachment, commonly found on cameras and similar devices.
Clip the holder onto the monitor's back. Observe the slots (two
at the bottom, one at the top). Start attaching the holder from
the bottom slots.

10. ChargIng The baTTery

The battery is built-in and can be charged via the supplied USB
cable (21) (Type A to type Mini B).
A full charging cycle takes approximately 4 – 6 hours.
A brand new battery should be charged between 6 and
10 hours during first charging cycle. A new battery will
reach its full potential after a few charging cycles.
If you do not use the monitor for a longer period of
time, then charge it every 2 – 3 months.
Charging indicators
Pay attention to the battery charging states:
Full Half
When the battery is depleted the battery indicator flashes.
Little Depleted
11