RC Logger 89050RC Instructions D'utilisation page 17

sub-2 dwell Time:
> Set the time (in seconds) for which each channel is scanned
for during auto channel selection. If there is no valid signal
after elapse of the set time, the monitor skips to the next
channel. The lower the set dwell time the less the impact
on battery life.
sub-1 recorder resolution
> Choose the desired recording resolution.
sub-1 frame rate
> Choose the desired frame rate.
sub-1 video segment size
> With video segment size you can restrict the length of
recorded videos. After the set time has elapsed a new file
is allocated.
sub-1 overwrite
> The overwrite function allows you to always save the latest
recorded video clip. To activate overwriting confirm with
"On". To cancel overwriting confirm with "Off". When storage
is full, then previously saved clips are overwritten.
sub-1 Time stamp
> If you like a time stamp to be added to your recordings
activate the function with "On". Deactivate the function with
"Off".
sub-1 Information display:
> If you like to display Time, Date, Mode, Channel, Recording
size on the display (7), then activate the function with "On".
Deactivate the function with "Off".
sub-1 video setting:
> Select "Brightness" and adjust brightness value for video
with buttons and
> Select "Contrast" and adjust contrast value for video with
buttons and and save with button
and save with button .
.
17