Nolan N702 X Sécurité Et Instructions D'utilisation page 23

WARNING
- Use the special slider to activate/deactivate the VPS; do not deactivate the VPS
by handling it directly.
- The VPS can only be used during the day and under the environmental conditions
described before.
- At night and/or in conditions of poor visibility, the VPS must be deactivated.
- Always ensure that the VPS is properly positioned according to different weather/
environmental conditions and/or the recommendations for use outlined above.
- We recommend using the VPS only and solely together with the approved stand-
ard visor, which has a transmittance value greater than 80%.
- The VPS does not replace the protection guaranteed by the visor.
- Always make sure that the VPS is clean and that it is operating properly in order to
avoid scratches and/or anomalous wear on it every time it is activated.
- As for VPS and visor maintenance and cleaning operations, please refer to the
appropriate section in the helmet user's manual.
- The VPS scratch resistant/fog-resistant treatment highly reduces fogging. Pro-
tracted periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction of
visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-resist-
ant treated VPS quickly reduces sharpness of vision, thus causing scarce visibility:
in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other mate-
rials might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended to make sure the VPS is not touching other materials.
3 DISASSEMBLING THE VPS
3.1 Open the helmet visor and lower the VPS completely (see instructions above).
3.2 Hold the left side part of the sunscreen and pull it toward the outside of the helmet
(Fig.17).
3.3 Repeat the same operation on the right side of the helmet.
4 ASSEMBLING THE VPS
4.1 Open the helmet visor completely and move the side slider completely (see in-
structions above) (Fig.15).
4.2 Insert the sunscreen left end into the left side guide until it is hooked into the shell
seat (Fig.17).
4.3 Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by activating and deactivating the side
slider (see instructions above).
If necessary, repeat the above-mentioned operations.
- If the VPS opening and closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolangroup authorized dealer.
INSTRUCTIONS FOR USE
N70-2 X
23