Nolan N702 X Sécurité Et Instructions D'utilisation page 20

N70-2 X
dealer.
- When using the helmet without the visor, assemble the side plates always.
- Do not remove the side mechanisms from the shell.
VISOR (NJS-10S / NJS-10L)
The visor comes in two sizes, depending on the size of the shell:
- Small (for sizes XXS to M)
- Large (for sizes L to XXXL)
Should you buy the visor as an accessory/spare part, we kindly request you to check
the correct size of the visor from a Nolangroup authorised dealer.
1 DISASSEMBLING THE VISOR
To disassemble the visor, first remove the peak if assembled (see instructions above).
1.1 Open the visor completely.
1.2 Push the release lever of the left side mechanism completely downwards (Fig.10)
and simultaneously push the visor away from the helmet initially projecting the
lower hook "A" and then the top hook "B" from the corresponding seats in the side
mechanism (Fig.11).
1.3 Follow the previous operations on the right side of the helmet.
2 ASSEMBLING THE VISOR
2.1 Position the left side part of the visor on the corresponding side mechanism by in-
serting the top hook "B" of the visor into the corresponding seat in the mechanism
and aligning the lower hook "A" of the visor above the corresponding seat in the
mechanism (Fig.11).
2.2 Press the visor at the lower hook "A" so that the release lever recedes and then
returns to position hooking, with a click, the visor to the side mechanism (Fig.10).
2.3 Follow the previous operations on the right side of the helmet.
2.4 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned operations.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
(Available as standard or accessory/spare part)
1 ASSEMBLING THE PINLOCK
1.1 Disassemble the visor (see instructions above).
1.2 Ensure that the inner surface of the visor is clean and ensure that the pin adjust-
ment external levers are positioned inwards (Fig.12).
1.3 Place the PINLOCK
20
INSTRUCTIONS FOR USE
INNER VISOR
®
inner visor on the visor.
®