Pioneer DDJ-ERGO-K Guide De Démarrage Rapide page 6

6 At the [Are you using an external mixer?] item, select
[Yes] if using an external mixer, [No] if not, then click
[Next].
7 Click [Finish] at the bottom right to complete the
setup wizard settings.
Cautions
The preferences are reset after the setup wizard settings are made.
When using the DDJ-ERGO-K, note that the audio settings below are
required at a minimum.
! Audio Setup
— Audio Device:
Pioneer DDJ ASIO (Windows 7)
PIONEER DDJ-ERGO (Mac OS X 10.6/10.7)
! Output Routing
— Mixing Mode:Internal
— Output Monitor:
L 3:DDJ-ERGO PHONES L
R 4:DDJ-ERGO PHONES R
— Output Master:
L 1:DDJ-ERGO MASTER L
R 2:DDJ-ERGO MASTER R
6
En
! Input Routing
The initial settings for TRAKTOR LE 2 are shown below.
To use external inputs with the initial settings, make the settings
below.
These settings are not required when not using external inputs.
— Input Aux:
L(Mono) 1:DDJ-ERGO AUX/MIC L
R 2:DDJ-ERGO AUX/MIC R
8 Open [File]>[Controller Manager...] if using windows,
[Traktor]>[Preferences]>[Controller Manager] if using
Mac OS X, then from [Device] under [Device Setup],
select [PIONEER DDJ-ERGO - Generic MIDI] and set
the device corresponding to this unit for [In-port] and
[Out-port].
9 Close TRAKTOR 2, turn this unit's power off then back
on, then relaunch TRAKTOR 2.
This completes all of the settings.