Basic Working Techniques With K 7000 Smartguard - Husqvarna K 7000 Manuel D'utilisation

• Feed the product down in line with the blade.
Pressure from the side can cause damage to the
blade and is very dangerous.
• Move the blade slowly forward and rearward to get a
small contact area between the blade and the
material to be cut. This decreases the temperature of
the blade and is an effective way to cut.
Basic working techniques with K 7000
SmartGuard
WARNING:
is disengaged if the SmartGuard is manually
retracted. Only retract the SmartGuard
manually if you must and there are no risks
of kickback.
SmartGuard gives more coverage of the blade. This
decreases the risk that you touch the blade if a kickback
occurs.
• You can retract the SmartGuard manually with the
SmartGuard handle.
• Hold the SmartGuard handle with a left hand finger
while the remaining fingers hold the front handle at
the same time.
22
The SmartGuard function
To do a check of the RCD 3 phase
1. Start the product, refer to
page 23 .
2. Look into the inspection holes and push the RCD
test button.
3. Make sure that the RCD moves and that it
disconnects the product from the power supply.
4. Turn the RCD reset knob to reset the RCD.
To connect the water supply
CAUTION:
operate the product. The temperature of the
product is decreased by water also during
dry cutting.
CAUTION:
to keep the diamond blade core and
segments cool when you cut. Diamond
blades for wet cutting cannot be used dry.
To start the product on
Always use water when you
Use correct water pressure
1635 - 003 - 20.08.2021