Menu Options - Milwaukee 48-22-9802 Manuel De L'utilisateur

MENU OPTIONS

LENGTH
Make a simple, single length measurement. The
length measurement is stored in HISTORY.
While in the Length mode, use the
add and subtract subsequent measurements.
SURFACE AREA
Height x Length
Make a height and a length measurement to calculate
surface area. The surface area is stored in HISTORY.
TOTAL AREA
(Height x Length 1) + (Height x Length 2) ...
Make a height measurement and multiple length
measurements to calculate total area. Continue to
make length measurements. When all length mea-
surements are complete, press MENU
The surface area is stored in HISTORY.
VOLUME
Length x Height x Depth
Make a length, height and depth measurement to
calculate volume. The volume is stored in HISTORY.
INDIRECT H/L (48-22-9803 only)
Determine the height and length using an angled
(hypotenuse) measurement and the level. The height
and length are stored in HISTORY.
INDIRECT HEIGHT (48-22-9803 only)
Determine the height using two angled length
measurements and the level. Use a tripod or other
stable surface to make two length measurements.
The height is stored in HISTORY.
buttons to
to save.
!
HISTORY
Press the Menu button and use the
select HISTORY. Press OK. The last 20 measure-
ments/calculations are displayed. Note, the measure-
ments made to calculate surface area, total area,
volume, etc, are not stored in HISTORY. Only the
resulting calculation is stored.
Press the Clear/Power button to delete an entry.
Press the Menu button to return to the menu screen.
Additional measurements/calculations can be added
or subtracted from entries stored in HISTORY. Only
calculations of the same type (length, area, volume,
etc.) can be made.
To perform a calculation:
1. Use the buttons to highlight an individual
measurement from the HISTORY.
2. Press the OK button.
3. Make the measurement(s) to be used in the
calculation.
4. Press the OK button to save the new calculation
to HISTORY.
SETTINGS
UNITS -
Use the
unit display.
AUDIO -
Use the
on and off. The meter will retain the on/off setting until
it is changed again.
LANGUAGE -
Use the
display language. The meter will retain the language
setting until it is changed again.
MAINTENANCE
• Clean the tool with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents or solvents.
Error Message
If the error code 500 appears on the display, turn the
meter off and back on. If the problem continues, return
the tool to the nearest service center for inspection.
For repairs, return the tool to the nearest service center.
ACCESSORIES
Use only recommended accesso-
WARNING
ries. Others may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
SERVICE - UNITED STATES
1-800-SAWDUST
Monday-Friday, 7:00 AM - 6:30 PM CST
www.milwaukeetool.com
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
4
buttons to
buttons to select the desired
buttons to turn the audio beep
buttons to select the
Care
Repairs
(1.800.729.3878)