Wolf SE-2 Instructions De Montage page 10

Table of contents
Safety instructions
SE-2 Floor-Standing
Hot Water Tank
Floor-standing hot
water tank type SE-2
10
SE-2 Floor-Standing
Hot Water Tank
Technical Data ............................................................................................................11
Assembly ....................................................................................................................12
Pipework .....................................................................................................................13
Control or charging pump / electrical auxiliary heating system E2 / E4,5 / E6 ...........14
Commissioning / Frost Protection / Servicing .............................................................15
Fault-Cause-Remedy .................................................................................................16
The following symbols and signs are used in this description. These important
instructions concern personal safety and technical reliability.
"Safety instructions" identify instructions with which you must exactly
comply to prevent injury and damage to the equipment.
Danger through 'live' electrical components. Warning: Switch the ON/
OFF switch to OFF before removing the casing.
Never touch electrical components or contacts when the ON/OFF switch
is in the ON position. This brings a risk of electrocution, which may
result in injury or death.
The supply terminals are still "live" even when the ON/OFF switch is
OFF.
"Information" identifies technical instructions which you must observe
Warning
to prevent damage and avoid malfunctions.
Floor-standing hot water tank type SE-2-150 to -750 made of steel S235JR with quality
certification.
Corrosion protection by enamelling of the inner surface of the tank and heater coil in
accordance with DIN 4753, part 3. Additional corrosion protection through magnesium pro-
tection anode which can be used with all water conditions and in any pipe system.
SE-2
3043756_201501