Problems And Recommendations - ECOFOREST CM 01-04 Manuel D'installation Et Maintenance

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Reducing motor of auger screw.
Brass fitting and lubrication point.
5.14.
Clean the resistance driver's holder pipe.
5.15. To ensure the proper operation of the safety valve, it must be discharged at the end of each season or once a
year. To manipulate the discharge tab, the rear grille should be removed from the boiler. Once you have
access to the tab, lift it and check that discharge occurs. Warning: The discharge valve must be connected to
a drain trap and the water passage must be visible.
IMPORTANT: After cleaning or fixing, make sure the boiler operates correctly. Once you turn the boiler off or
during the seasons when you do not use it, disconnect the stove to avoid electronic damages
5.16.
Purge the system, as explained in point 4.
5.17. Controlling the combustion air inlet and gas outlet; make sure nothing prevents normal circulation (e.g. bird
nests).
5.18. It is recommended to clean the back side of the stove that you reach through the back grids or lateral doors,
in order to take eventual dust away that might have stacked during summer time.
6.

PROBLEMS AND RECOMMENDATIONS.

6.1.
Do not turn the boiler on and off successively because this might damage the electronical components and
motors ~230/240V - 50Hz.
6.2.
Do not touch the boiler while your hands are wet. Though the boiler is equipped with ground plug, it remains
an electric machine that could cause electric discharge if handled incorrectly. A qualified technician only shall
resolve the eventual problems.
6.3.
Do not remove any screw of the zones exposed to high temperature before they have been lubricated
properly with lubrication oil.
THE BOILER REMAINS OUT OF POWER:
6.4.
Make sure the boiler is connected and the plug is leading power.
6.5.
Make sure the cable is not damage or cut.
While the boiler is disconnected, dismantle the right door of the boiler and check if any lead of the C.P.U. is
slack.
6.6.
Check the C.P.U. pilot. If it is OFF, check also the fuse on the C.P.U.
CHECKING AT BEGINNING OF SEASON.
WHAT NOT TO DO.
WHAT DO TO IF...
39
Drawing 19

Publicité

Table des Matières
loading

Table des Matières