Makita UH004G Manuel D'instructions page 9

CAUTION:
Never put your finger on the
switch when carrying. The tool may start uninten-
tionally and cause injury.
NOTICE:
Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
Press the main power button to turn on the tool. To turn
off the tool, press and hold the main power button until
the speed indicators go off.
► 1 . Main power button
NOTE: The caution lamp brinks if the switch trigger
is pulled under unoperatable conditions. The caution
lamp blinks if you turn on the main power switch while
holding down the lock-off lever and the switch trigger.
NOTE: This tool employs the auto power-off function.
To avoid unintentional start up, the main power switch
will automatically shut down when the switch trigger
is not pulled for a certain period after the main power
switch is turned on.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever, and then press the switch
lever and pull the switch trigger. Release the switch
trigger to stop.
► 1 . Switch lever 2. Lock-off lever 3. Switch trigger
1
1
Speed adjusting
You can select the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
1
2
► 1 . Speed indicator 2. Main power button
For UH004G/UH005G/UH008G/UH009G
Indicator
For UH006G/UH007G
Indicator
2
3
9 ENGLISH
Mode Stroke speed
High 5,000 /min
Medium 3,600 /min
Low 2,000 /min
Mode Stroke speed
High 4,000 /min
Medium 3,000 /min
Low 2,000 /min