Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
1.
Hold the tool firmly with both hands when
using the tool.
The tool is intended to be used by the operator
2.
at ground level. Do not use the tool on ladders
or any other unstable support.
DANGER - Keep hands away from blade.
3.
Contact with blade will result in serious personal
injury.
Make sure you have a secure footing before
4.
starting operation.
5.
Do not operate the tool at no-load
unnecessarily.
6.
Immediately switch off the tool and remove the
battery cartridge if the shear blades should
come into contact with a fence or other hard
object. Check the blades for damage, and if
damaged, replace the blades immediately.
7.
Before checking the shear blades, taking care
of faults, or removing material caught in the
shear blades, always switch off the tool and
remove the battery cartridge.
Never point the shear blades to yourself or others.
8.
9.
If the blades stop moving due to the stuck of
foreign objects between the blades during
operation, switch off the tool and remove the
battery cartridge, and then remove the foreign
objects using tools such as pliers. Removing
the foreign objects by hand may cause an injury
for the reason that the blades may move in reac-
tion to removing the foreign objects.
10. Avoid dangerous environment. Don't use the
tool in damp or wet locations or expose it to
rain. Water entering the tool will increase the
risk of electric shock.
11.
When you use the tool on muddy ground, wet
slope, or slippery place, pay attention to your
footing.
12. Avoid working in poor environment where
increased user fatigue is expected.
13. Do not use the tool in bad weather where visi-
bility is limited. Failure to do so may cause fall or
incorrect operation due to low visibility.
14. Do not submerge the tool into a puddle.
15. Do not leave the tool unattended outdoors in
the rain.
16. When wet leaves or dirt adhere to the suc-
tion mouth (ventilation window) due to rain,
remove them.
17. Do not use the tool in the snow.
Electrical and battery safety
1.
Avoid dangerous environment. Don't use the
tool in dump or wet locations or expose it to
rain. Water entering the tool will increase the risk
of electric shock.
2.
Do not dispose of the battery(ies) in a fire.
The cell may explode. Check with local codes for
possible special disposal instructions.
3.
Do not open or mutilate the battery(ies). Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
4.
Do not charge battery in rain, or in wet
locations.
5.
Do not charge the battery outdoors.
6.
Do not handle charger, including charger plug,
and charger terminals with wet hands.
Do not replace the battery with wet hands.
7.
8.
Do not replace the battery in the rain.
9.
Do not wet the terminal of battery with liquid
such as water, or submerge the battery. Do not
leave the battery in the rain, nor charge, use,
or store the battery in a damp or wet place. If
the terminal gets wet or liquid enters inside of bat-
tery, the battery may be short circuited and there is
a risk of overheat, fire, or explosion.
10. After removing the battery from the tool or
charger, be sure to attach the battery cover to
the battery and store it in a dry place.
11.
If the battery cartridge gets wet, drain the
water inside and then wipe it with a dry cloth.
Dry the battery cartridge completely in a dry
place before use.
Maintenance and storage
Switch off the tool and remove the battery
1.
cartridge before doing any maintenance work.
When moving the tool to another location,
2.
including during work, always remove the
battery cartridge and put the blade cover on
the shear blades. Never carry or transport the
tool with the blades running. Never grasp the
blades with your hands.
3.
Clean the tool and especially the shear blades
after use, and before putting the tool into stor-
age for extended periods. Lightly oil the blades
and put on the blade cover.
4.
Store the tool with the blade cover on, in a dry
room. Keep it out of reach of children. Never
store the tool outdoors.
5.
Do not dispose of the battery(ies) in a fire. The
cell may explode. Check with local codes for
possible special disposal instructions.
6.
Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may be
toxic if swallowed.
7.
Do not wash the tool with high pressure water.
When washing the tool, do not let water enter
8.
the electrical mechanism such as battery,
motor, and terminals.
Perform inspection or maintenance in a place
9.
where rain can be avoided.
10. After using the tool, remove the adhered dirt
and dry the tool completely before storing.
Depending on the season or the area, there is a
risk of malfunction due to freezing.
When storing the tool, avoid direct sunlight
11.
and rain, and store it in a place where it does
not get hot or humid.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
5 ENGLISH
Publicité
Table des Matières
