Makita UH004G Manuel D'instructions page 12

10. Insert the protrusion on the shear blades to the
small hole on the rod, then align the position of the felt
pad with the holes on the tool, and then attach new
sleeves.
3
► 1 . Protrusion 2. Small hole 3. Sleeve 4. Felt pad
NOTICE:
Apply a small amount of grease to the
inner periphery of the hole of the rod.
NOTICE:
Be careful not to lose the sleeves.
11. Align the holes on the shear blades with the holes
on the tool, and then tighten 2 bolts to fix the shear
blades.
1
2
► 1 . Bolt 2. Hole
12. Attach the bearing and the rod.
1
► 1 . Rod 2. Small hole 3. Bearing
2
NOTICE:
inner periphery of the small hole of the rod.
NOTICE:
shear blades fits in the small hole on the rod.
13. Attach the plate.
4
► 1 . Protrusion 2. Plate
NOTICE:
shear blades fits in the hole on the plate.
14. Attach the cover, and then tighten 6 bolts.
► 1 . Bolt 2. Cover
12 ENGLISH
1
2
Apply a small amount of grease to the
Make sure that the protrusion on the
1
Make sure that the protrusion on the
1
3
2
2