Makita UH004G Manuel D'instructions page 11

3. Remove the rod and the bearing.
1
2
► 1 . Rod 2. Bearing
NOTE: The rod may remain on the cover.
4. Remove 2 bolts, the felt pad and the sleeves, and
then remove the shear blades.
1
2
3
► 1 . Felt pad 2. Bolt 3. Sleeve 4. Shear blades
5. Remove the blade cover.
6.
Attach the blade cover to the new shear blades.
7.
Adjust the crank so that 2 holes are lined up on
the alignment line.
1
► 1 . Hole 2. Alignment line
4
2
11 ENGLISH
8. Align the protrusions on the shear blades vertically
at the same position.
► 1 . Protrusion
9.
Attach the felt pad to the shear blades.
► 1 . Felt pad
1
1
1