Preset Store; Edit - Electro-Voice Dx46 Mode D'emploi

Table des Matières

Les langues disponibles

5.7 Preset Store

Edited presets can be stored in one of 30 User Preset locations. (U01 to U30) To store a preset, press the

button. The LCD display will switch to the Store Preset screen.

Use the Value Up and Down buttons to select the user destination. Press the < SELECT > buttons to navigate down

to the preset name field. Use the Value Up and Down buttons to select the field for each letter / symbol character.

The Dx46 provides the complete ANSI character set, including lower-case & upper-case letters, numerals and sym-

bols. Pressing and holding the Value Up and Down buttons will scroll rapidly through the character set. Press the <

SELECT > buttons to move to the next or previous character position. Finish the name editing by pressing the Store

button. The display shows „Save Edits? Hit ‚Store'" or „Save Unedited? Hit ‚Store'".

Press Store again to proceed and store the new preset.

To Exit Store without saving the edited preset, press the Edit, Setup or any of the DSP block buttons. (Edit or Setup

buttons will return the display to run-time mode. DSP block buttons will display the corresponding DSP block edit

screen.)

Both Factory and User presets can be edited, but edited presets can only be stored in User preset locations.

TANDARD

DIT MODE

The Dx46 defaults to Standard Edit mode wherein, input and output channel parameters are appropriately linked.

Refer to the illustrations in chapter "Configurations of the Dx46" on page 39 to see which channels are parameter-

linked for each configuration. Linked parameters are always identical in value. For instance, setting a graphic eq

curve for Input A, sets the same curve for Input B, if the configuration has linked stereo inputs. Either input channel

can be edited; changes will be reflected in both. The same is true for parameters of linked output channels. The only

exception to the linking of parameters is the Mute buttons. Output channels can be individually muted at any time,

either from the Dx46 front panel or the IRIS-Net application.

ULL

DIT

ODE

In the Setup EDITING menu, the edit mode can be changed to Full. In Full Edit, no parameter links are enforced,

regardless of the configuration selected. Any parameter can be changed without any effect on other parameter val-

ues.

Store Preset: U01

Name: Default User Preset 1

Press 'Store' to continue

Save Edits? Hit 'Store'

Any other key to cancel

Setup: EDITING

Edit Mode: Standard

Link: Off

Setup: EDITING

Edit Mode: Full

Link: Off

Store

Table des Matières