Preset Recall; Signal Generator - Electro-Voice Dx46 Mode D'emploi

E -V
LECTRO OICE

PRESET RECALL

The Dx46 allows the recall of presets by using external switches connected to the CONTROL PORT, see page 20.
This window allows the assignment of Presets to the pins of the CONTROL PORT.
Use the <SELECT> buttons to navigate to the Port parameters. Use the VALUE up/down buttons to select a user
preset (U01 to U30), factory preset (F01 to F60) or Off if no preset should be loaded.
The Control Port Contacts parameter is used as a display only and corresponds to the binary values of individual
pins, ie - on/off.

SIGNAL GENERATOR

The integrated signal generator of the Dx46 can generate following signal types:
• Sine signal
• White Noise
• Pink Noise
This window allows editing the generated signal type and signal level for each input channel.
The selected type is always used for both input channels. The Frequency parameter is only available when Type:
Sine is selected.
INPUT
This window is where the audio input can be configured.
Use the <SELECT> buttons to navigate to the Audio parameter. Use the VALUE up/down buttons to choose be-
tween Analog and Digital input. When using the analog input the -6dB PAD can be activated. The activated -6dB
PAD is indicated by the -6dB LED on the Dx46 rear panel.
For each of the two audio inputs a gain can independently be set (-60 dB to +12 dB). This can be useful if the level
of two mono signals should be adjusted, without editing the presets.
DISPLAY
This window allow the user to adjust the contrast preferences of the LCD screen and the brightness of the front
panel buttons to compensate for different lighting conditions that may be encountered within different venues. Ad-
ditionally a screensaver can be activated.
Use the < SELECT > buttons to navigate to the Contrast parameter. Use the VALUE up/down buttons to choose
between: -10 to +10 LCD contrast. Use the < SELECT > buttons to navigate to the Brightness parameter. Use the
VALUE up/down buttons to edit the brightness of the buttons. Use the < SELECT > buttons to navigate to the
Screensave parameter. Use the VALUE up/down buttons for enabeling or disabeling the screen saver.
22
Setup: PRESET RECALL
Port(State): 1(1) 2(1) 3(1) 4(1) 5(1)
Preset: Off Off
Setup: SIGNAL GENERATOR
Type: Sine Frequency: 1000Hz
A: Off -60.0dBu
Setup: INPUT
Audio: Analog
Gain A: 0.0dB
Setup: DISPLAY
Contrast: 0 Brightness: 1
Screensave: disable
Off Off Off
B: Off -60.0dBu
-6dB PAD: Off
Gain B: 0.0dB