Rear Panel - Electro-Voice Dx46 Mode D'emploi

E -V
LECTRO OICE
22 – O C
UTPUT HANNEL
Each output channel has a lighted Mute button. Pressing the Mute button turns off the output of that channel. The
button lights red as an alert. Press the Mute button again to restore the output channel's signal. Output channels
may also be muted from IRIS-Net Application, if the unit is connected to a PC. Muting a channel in any window of
the application will light the channel Mute button on the front panel of the unit as well.
23 – O C
UTPUT HANNEL
Each output channel has a four-segment function display for informational purposes only. For any given configuration
possible with the Dx46, an output channel may be identified as a sub, low, low/mid, mid, mid/hi, hi or full range out-
put. One or two adjacent LED are displayed to indicate all possible output bandpasses. (Full range is indicated by
no lit LED's.)

3.2 Rear Panel

24 – A.C. I
NLET
The Dx46 features a standard IEC A.C. inlet that will accept universal power cords. The Dx46 power supply is auto-
ranging and can accept voltages from 100 to 240 V AC, 50 to 60 Hz. Only A.C. cords approved for use in your
country should be connected to the Dx46.
25 – A.C. F
USE
The A.C. inlet includes a fuse holder that contains the mains fuse as well as a spare fuse. If necessary, replace the
fuse only with a specified 5x20mm, T800 mA, L250 V replacement. Disconnect A.C. power before replacing a fuse.
Before turning the unit back on, assess the condition of the A.C. receptacle powering the Dx46. If fuses continue
to blow, refer servicing of the Dx46 only to qualified service personnel.
26 – A.C. P
OWER SWITCH
The A.C. power switch turns power to the Dx46 On and Off.
27 – CONTROL PORT
The CONTROL PORT of the Dx46 provides five control inputs and a reference connection for ground. The control
inputs can be used for the recall of presets.
16
M
UTE BUTTONS
F
UNCTION INDICATORS