Iris-Net; Quick Start - Electro-Voice Dx46 Mode D'emploi

E -V
LECTRO OICE

2.3 IRIS-Net

The IRIS-Net (Intelligent Remote & Integrated Supervision) PC software is used to configure and operate the Dx46.
The configuration of the Dx46 can be done offline (i.e. without connection between the PC and the Dx46) on the
PC. After the connection between the PC and the Dx46 has been established via Ethernet or USB, the configuration
can be transmitted to it. In addition to configurations, IRIS-Net can also be used for extensive supervision, control
and monitoring of the Dx46. The latest version of IRIS-Net is available at www.electro-voice.com.

2.4 Quick Start

C D 46
ONNECT X
Connect the signal inputs and outputs of the Dx46 (console - Dx46 - amplifier). You must make sure that each output
is connected to the correct amplifier and loudspeaker(s). The Dx46 must be connected to A.C. power only by means
of the provided IEC A.C. cable or by a power cable provided by the dealer / installer to match the configuration of
your country or region. After power-up the number and name of the last loaded preset and the configuration mode
is indicated.
R P
ECALL RESET
Press the Recall button and select the factory preset matching to your speaker configuration. Press the Recall button
again to activate the preset. If the configuration of the Dx46 changes the Recall button has to be pressed a third time.
The configuration LEDs indicate the function of each output channel. Full range is indicated by no lit LEDs.
10
Electro-Voice Dx46
Default User Preset 1
U01
FREE CONFIGURATION