Output Channel Function Indicators; Presets Recall - Electro-Voice Dx46 Mode D'emploi

E -V
LECTRO OICE

5.5 Output Channel Function Indicators

Each output channel has a four-segment function display for informational purposes only. For any given configuration
possible with the Dx46, an output channel may be identified as a sub, low, low/mid, mid, mid/hi, hi or full range out-
put. One or two adjacent LED's are displayed to indicate all possible output bandpasses. (Full range is indicated by
no lit LED's.)

5.6 Presets Recall

The Dx46 preset memory provides 60 factory presets and can store up to 30 user presets (F01 to F60, U01 to U30).
Factory presets have been designed to represent common system configurations utilizing Electro-Voice loudspeak-
er systems. User presets allow you to accommodate other system configurations and / or loudspeaker systems.
To recall a preset, press the front panel
the next in a list of available presets in memory.
Using the Value Up and Down buttons, select the preset to be recalled and press Recall again. The display will
prompt, "Press ‚Recall' to load"
Press Recall a third time to confirm and load the new preset. If the preset you are recalling is based on a configura-
tion different from that of the current preset, the display will prompt, "Changing config can damage speakers", to
remind you that the new preset may not be appropriate for your system as it is currently connected. Press Recall
again to confirm and load the new preset.
CAUTION: Make sure that the new preset is appropriate for your system, and that connections to
your system are correct for the current configuration. Failure to do so could cause unex-
pected results or damage to the system or its components.
To exit the Recall process without loading a new preset, press the Edit, Setup or any of the DSP block buttons. (Edit
or Setup buttons will return the display to run-time mode. DSP block buttons will display the corresponding DSP
block edit screen.)
28
Illustration 5-4: Output channel function indicator
button. The display switches to the Recall Preset screen and displays
Recall
Recall Preset: U01
Name: Default User Preset 1
Press 'Recall' to continue
Press 'Recall' to load
Any other key to cancel