Pad - Gong RIGID BOARDS Série Guide De L'utilisateur

PADS
Some SUP, WING, Surf, Foil and KITE Boards come with Pads.
We could offer you pads glued with resin in factory, impossible to peel off.
But a Pad is something that undergoes some serious wear and tear and that should be relatively easy to replace
if needed.
GONG GALAXY has therefore chosen to equip our Boards with Pads glued with a top-of-the-range 3M adhesive.
It offers you the best compromise between adhesion and renewability.
However, you must be alerted on certain points of vigilance:
• When you receive your Board, press the Pad well over its entire surface to obtain a long-lasting 3M adhesion,
a pastry roller in the kitchen is perfect for this.
• Exposure to extreme heat can cause the pad to come off.
• As soon as you notice that the Pad is starting to peel, re-glue it immediately before sand gets between the
Pad and the Board. Use strong gel glue such as Loctite/Pattex between a perfectly dry Pad and Board.
If needed, you can order the replacement Pad for your Board at GONG-GALAXY.com or by contacting our
sales department via our online contact form.
TAKING OFF A PAD
Peel off the old PAD. Remove 3M adhesive residues with F-glue soaked in F-glue soaked in cloths placed on
EN
Step 1
the glued area for ten minutes.
- 36