Hitachi DS 10DFL 2 Instructions De Sécurité Et Mode D'emploi page 15

Work
Wood
Drilling Steel
Aluminum
Small
screw
Screw
tightening
Wood
screw
CAUTION
● While operating the Cordless driver drill, take care
not to lock the motor.
If the motor is locked, immediately turn the power
off.
If the motor is locked for a while, the motor or
battery will be burnt.
● Do not tighten too strongly as the screw heads will
be damaged.
Use
Machine screw
Driving
Wood screw
Wood
Drilling
Metal
11. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
●
When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
●
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
Table 5
Clutch dial position
1 – 21
1 –
Table 6
Rotating speed selection (Position of the shift knob)
Clutch dial position
For 6 mm or smaller
1 – 21
diameter screws.
For 5.8 mm or smaller
1 –
nominal diameter screws.
For 29 mm or smaller
diameters.
Suggestions
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
10. How to select tightening torque and rotational
speed
CAUTION
● The selection examples shown in Table 6 should be
considered as general standard. As different types
of tightening screws and different materials to be
tightened are used in actual works proper
adjustments are naturally necessary.
LOW (Low speed)
(1) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 12)
Hook
English
HIGH (High speed)
For 6 mm or smaller
diameter screws.
For 3.8 mm or smaller
nominal diameter screws.
For 12 mm or smaller
diameters.
For drilling with a metal
working drill bit.
Screw
Fig. 12
15