Remote Control Unit; Turntable Cover - Teac LP-R660USB Mode D'emploi

Remote Control Unit

Using the provided remote control unit, you can also operate the
unit.
When operating the remote control unit, point it toward the remote
sensor on the front panel of the unit.
< Even if the remote control unit is operated within the effective
range, it may not work if there are any obstacles between the
unit and the remote control.
< If the remote control unit is operated near other appliances which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
Conversely, the other appliances may operate incorrectly.
Battery Installation
1
Remove the battery compartment cover.
2
Insert two "AA" (R6, SUM-3) dry batteries. Make sure that the
batteries are inserted with their positive "+" and negative "_"
poles positioned correctly.
3
Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
For more information about collection of batteries, please
contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.

Turntable Cover

To attach the turntable cover
1. Slide the hinges into the hinge sockets on the rear of the
turntable.
2. Align the hinge sockets on the turntable cover with the top of the
hinges, and slide the cover down into place.
To detach the turntable cover
Hold the cover on both sides and gently pull upward to remove
it from the hinges.
How to open/close the turntable cover
To Open
Lift the turntable cover halfway until it stops.
< The cover will now stay open.
To Close
Slowly lower the cover until it touches the turntable base.
Note:
Make sure you grasp the cover by the front edge to avoid
removing hinges.
Be careful not to pinch your fingers when the cover closes.
9