Recording Into A Computer; Adjusting The Recording Level - Teac LP-R660USB Mode D'emploi

USB connection
Computer
This unit has a USB port to output sound signals. Connect this unit
to your computer via the USB so that sound signals from the unit are
converted into digital data and sent to the computer.
Connecting this unit to a computer
o Use a commercially-available USB cable.
1 Turn your computre on.
Check that the operating system starts properly.
2 Insert one end of the USB cable into this unit and the other
end into your computer.
3
To turn this unit on, press the POWER button on the unit.
The computer connected to this unit automatically detects the
USB port on the unit and recognizes the port as "USB Audio
CODEC".
To record the sound from the unit with your computer, you need to
install a recording software on your computer.
< If you set the recording device setting on the recording software
to "USB Audio CODEC, " you can record the sound output from the
USB port on this unit into the computer.
For detailed information, see the instruction manual for your
recording software.

Recording into a computer

USB cable
Selecting a recording source
You can send the sound that the unit is playing to your computer.To
select a source you want to play, press the appropriate button.
< To listen to an external source connected to AUX jacks, select AUX
by pressing the PHONO/TAPE/AUX button once or twice.

Adjusting the recording level

To adjust the volume level of the sound data that is sent from this unit to
your computer, turn the LEVEL knob on the right of the USB port. Using
the recording software on your computer or thecomputer itself, check
the volume level of the sound from this unit,and then adjust the sound
level by turning the LEVEL knob so that the sound is not distorted.
o If you can adjust the recording level by using the
software on your computer, set the recording
recording software to middle first, and then adjust the recording
level on this unit.
o DO NOT perform any of the following operations while the sound
is being recorded into your computer from this unit through the
USB connection. Failure to follow the instruction could cause the
computer to malfunction. Be sure to exit the recording software on
your computer before you perform any of the following operations.
N Unplug the USB cable.
N Turn this unit off.
recording
level on the
31