Replacing The Bulb - Electrolux EC3340AOW Notice D'utilisation

Problem
It is too cold inside
the freezer
The appliance does
not work at all.

8.1 Replacing the bulb

If it becomes necessary to replace the
lamp:
WARNING!
Do not operate the freezer if the
lamp cover is damaged or miss-
ing.
Possible cause
Large quantities of food to
be frozen were put in at
the same time
Food placed in the appli-
ance was too warm
Products to be frozen are
placed too closely to each
other
The temperature is not set
correctly
Plug is not connected to
the mains socket properly
Power does not reach the
appliance
The appliance is not
switched on
There is no voltage in the
mains socket (try to con-
nect another appliance in-
to it)
• break the circuit of the appliance
• remove the lamp cover with a screw-
• replace the bulb with one of the same
• replace the lamp cover and reconnect
Solution
Wait some hours and then
check the temperature
again. Next time insert
smaller quantities of food to
be frozen at any one time.
Allow food to cool to room
temperature before storing.
Place the products in a way
so that cold air could circu-
late among them
Set a warmer temperature
Connect the mains plug
properly
Try connecting another
electrical device to the
power outlet
Switch on the appliance
Call an electrician
driver as shown in the graphic
power and specifically designed for
household appliances. (the maximum
power is shown on the light diffuser)
the appliance
ENGLISH 31