Functions Menu; Excessive Temperature Alarm; Child Lock Function - Electrolux EC3340AOW Notice D'utilisation

24 www.electrolux.com
The temperature may be regulated by
pressing the Temperature regulation but-
ton.
By pressing the Temperature regulation
button the current temperature setting
flashes on the indicator and by pressing
the button again it is possible to change
it.
You confirm the choice of the temperature
by pressing the Confirmation button. The
temperature indicator shows again the in-
side compartment temperature.
The set temperature will be reached with-
in 24 hours.
After a long period out of use it is not nec-
essary to set again the temperature be-
cause it remains stored.
WARNING!
During the stability period by the
first starting the temperature dis-
played can not correspond to the
setting temperature. During this
time it is possible that the temper-
ature displayed is different than
the setting temperature.
Difference between the tempera-
ture displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selec-
ted
• the door has been left open for a long
time
• warm food has been placed in the
compartment
Difference until 5°C inside the compart-
ment are quite normal.
During normal functioning the indicator
shows the warmest temperature inside
the compartment.

3.5 Functions Menu

By activating the Function button the
functions menu is operating. Each func-
tion could be confirmed by pressing Con-
firmation button . If there is no confirma-
tion after some seconds the display will
go out from the menu and return in nor-
mal condition. The following functions are
indicated:

Excessive temperature alarm

Child Lock function

Eco Mode function
Frostmatic function
Drinks Chill function
3.6 Excessive temperature
alarm
An increase in the temperature in a com-
partment (for example due to an power
failure) is indicated by:
• flashing the alarm and freezer tempera-
ture indicators
• sounding of buzzer
When normal conditions are restored:
• the acoustic signal shuts off
• the temperature value continues to
flash
When you press the Confirmation button
to de-activate the alarm, the highest tem-
perature reached in the compartment ap-
pears on the temperature indicator for
some seconds.
Then it returns on the normal operation
showing the temperature of the selected
compartment.
During the alarm phase, the buzzer can
be switched off by pressing the Confirma-
tion button.
Possible causes of alarm:
• Large volume of fresh food was inser-
ted.
• The lid has been left open for a long
time.
• Any other defect of the system. See the
table in "Troubleshooting".
3.7 Child Lock Function
The Child Lock function is activated by
pressing the Function button (several