Functional Description; Depth Adjustment - Makita FS4000 Manuel D'instruction

Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
USD201-2

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.

Depth adjustment

A
009960
The depth can be adjusted by turning the lock ring. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the lock ring equals 2.0 mm
(5/64") change in depth.
Adjust the lock ring that the distance between the tip of
the locator and the screw head is approximately 1 mm
(3/64") as shown in the figures. Drive a trial screw into
your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue
adjusting until you obtain the proper depth setting.
1mm (3/64")
002619
1mm (3/64")
002620
4
B
1
1
1
1. Lock ring
1. Locator
1. Locator