Electrolux EHH6332FOK Notice D'utilisation page 13

Problem
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
comes on.
and a number come
on.
comes on.
If you tried the above solutions and can-
not repair the problem, speak to your
Possible cause
The highest heat setting
is set.
The Power management
is activated.
The cookware is too
large or you put it too
near to the controls.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones
and the Automatic
Switch Off operate.
dealer or the customer service. Give the
data from the rating plate, three digit letter
ENGLISH
Remedy
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on the
rear cooking zones if nec-
essary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Daily
Use".
Put cookware on the
cooking zone.
Use the correct cookware.
Move cookware to a
smaller cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If comes
on again, speak to the
service centre.
Deactivate the appliance.
Remove the hot cook-
ware. After, approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appliance.
13