Possible Error Messages; Reset After Error Message - Schick QUBE Mode D'emploi

14. Possible error messages

The control unit has an intelligent control electronics system which
recognises possible defects and can display them with an error code on the control unit.
If there is a defect, this is shown with a flashing red light on the controls satellites, with a flashing red
SCHICK-logo on the
"E xxyy".
Example:
Error code: E 0201 - no motor connected

14.1 Reset after error message

Error messages will disapear immediately from the display when the control level is released or the fault
is eliminated. This means no waiting times for a restart.
Exception: If the table top model is used without a footswitch reset of the error messages by simultaneously
press and hold the reset touch fields Menu +
+ for 2 sec., or by disconnecting the mains supply.
If an error cannot be removed following the above description, please contact an authorised service partner
or Schick directly.
15. Set up suggestions for the electric wax knife
The heating power of the electric wax knife can be ajusted from level 1 to 20.
The following set up suggestions are based on the Schick DesignWax and can be used as an example
for individual adjustments.
Wax
Cervical wax lila
Ceramic wax yellow
Modelling wax grey
Milling wax green
control unit and with an error message with the following format
+
Set up
Level 10
Level 11-12
Level 15
Level 15-17
. A full reset can be done by pressing the touch fields
Working temperature
approx. 125°C
approx. 130° - 135°C
approx. 140°C
approx. 140° - 150°C
18