Schick QUBE Mode D'emploi page 29

8. Use of operating units
There is continuously variable speed control of the handpiece up to the maximum preset motor speed using
the respective control unit (see diagram below). Exception: using the footswitch that is attachable to the
bench control unit, the handpiece is regulated directly to the preset speed when activated. In relation to this,
please see the instructions given in point 9.
table top model: Start/Stop
alternative with touch-field Menü
9. Basic and additional functions, time and thermometer
9.1 Pre-selection of maximum speed
1.
1. Adjust the maximum speed by making a rotational motion on the wheel.
For using the speedrange between 200 and 1.000 rpm, the maximum speed has to be limited to
1.000 rpm at the control satellite
Please always observe the maximum permitted speed for your tools!
Flashing of the rpm symbol illustrates the pre-selected rpm when the motor is not running.
If the handpiece is started using the knee pad or foot lever, the display changes
to the current rpm and the rpm symbol is displayed permanently.
When operating the motor hand piece without the controls satellite, the maximum speed
is restricted to 30,000 rpm.
foot pedal switch 6370/2 for
connection to the bench control unit
9
Foot control 6371/2 for
connection to the bench control unit