Schick QUBE Mode D'emploi page 37

After thoroughly cleaning the chuck, before replacing, it should be slightly greased on the outer surface
(e.g., with Vaseline).
Only fasten the chuck lightly when reinstalling! The chuck will fix itself firmly as part of its normal operation.
To optimise the precision and durability of the chuck, a tool or the factory supplied protective pin
must always be fixed, even when not in use.
Never clean the handpiece with compressed air!
The required chuck keys are located in the underside of the handpiece holder.
13.3 Removing/changing the motor cable
1.
(a)
2.
1. Unscrew the tip (a) of the handpiece, pull the grip casing (b), the ring (c) and cable cap (d) in the
direction of the arrows
2. Detach the plug element of the motor cable from the handpiece
13.4. Removing/changing the motor cable on the motorhandpiece
1. Unscrew the cap (2) from the motor
2. Loosen the cable by pulling out the plug-in seal (1)
on the short
(c)
(b)
handpiece
long version (see picture page 16)
17
(d)