Tool Change On Motorhandpiece - Schick QUBE Mode D'emploi

6.3 LCD- Information display
The symbols
Motor speed
Torque display

7. Tool change on motorhandpiece

By turning the handle on the hand piece, the chuck can be opened or closed
Only carry out a tool change when the motor is switched off! To optimise the precision and durability
of the chuck, the tool or the factory-supplied protective pin must always be in a fixed position,
even when not in use.
Always insert tools as far as possible into the chuck in order to achieve maximum holding power!
Rotation direction
Motor speed
Time/Stopwatch/Countdown
close
open
8
Handpiece 1/2
Programme selection
12/24 hour display
Mode Date display
Hold firmly here
Speed control
electric
wax knife