Front Wheels - Baby Jogger city mini 2 Instructions D'assemblage

FRAME
1 Unpack the pushchair frame from
the box and set the wheels aside.
Unlock the pushchair by pulling the
storage lock lever.
2 Unfold the pushchair by pulling the
handlebar away from the frame.
3 The pushchair will lock into place
and you will hear a click.
WARNING: Ensure that all the
locking devices are engaged before
use.

FRONT WHEELS

4 Installation
• Lay pushchair on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding
it into the front wheel mount until
it clicks. Gently pull on the front
wheel to make sure it is properly
attached.
5 Removal
• While pressing the front wheel
release button, gently slide the
front wheel out of the front wheel
mount.
SWIVEL FEATURE
6 Press the Swivel Lock button down
and slide the Swivel Lock to the left
to lock the front wheel assembly
in a fixed position for long distance
strolling.
7 Press the Swivel Lock button
down and slide the Swivel Lock to
the right to allow the front wheel
assembly to swivel.
WARNING: When loading and
unloading child, lock the front
wheels in a fixed position. Although
the front wheels of your pushchair
lock, it is not intended for jogging or
exercise purposes.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the pushchair
frame and insert it into the wheel
mount until it locks into place. You
will hear a click.
• Gently pull on the rear wheel to
make sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes.
11 To release the brakes: lift the brake
lever up.
WARNING: Lock the brakes before
loading and unloading your child
and whenever the pushchair is not
moving.
CANOPY
12 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets. To remove, slide
canopy off of mounts.
NOTE: When using a City Go/
Graco or Britax car seat, the
canopy must be in the top
position. For all other car seats,
canopy must be removed.
13 Snap the two snaps to the
pushchair frame.
14 Zip the back of the seat to the
canopy top.
Attach the 2 fastening strips on the
side of the canopy.
15 Pull forward to open canopy and
push backwards to close canopy.
16 There are two canopy windows, a
top one and back one. To use them,
roll the shade up towards the top
and secure with the elastic and
button.
ADJUSTING SAFETY HARNESS
17 From the back of the seat, unfasten
and open the pocket to locate the
plastic square stopper. Turn stopper
and pass through the openings in the
PE board and seat fabric.
18 Reinsert stopper at seat opening
closest to child' s shoulders. Pass
back through seat fabric and PE
board. Tug on strap to ensure
stopper is locked. Repeat on both
sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
11
EN