Glow Fire Neptun Mode D'emploi page 54

Button
Info When the heat function is used for the first time, there may be a slight smell. This is
normal and should not be repeated if the heater is used normally afterwards.
ACTION / FUNCTION
ON: Enables the panel functions and
Remote control. Turns on the flame
effect.
OFF: Disables the function key functions
and Remote control. Turns off the flame
effect.
TIMER button: Setting the automatic
switch-off time of the fireplace.
The settings range from 0.5 hours to 7.5
hours. The switch-off time is extended
by 30 minutes each time the button is
pressed.
FLAME "-": Makes the flame effect
weaker.
NOTE: The flame effect remains on
There must be a flame effect
to be able to switch on the heating.
FLAME "+": Brightens the flame effect.
NOTE: The flame effect remains on
There must be a flame effect
to be able to switch on the heating.
HEATER button: switches the heating on
and off.
NOTE: The heating only works if the
Flame effect is switched on. If the flame
effect is turned off,
The heating element does not switch on.
NOTE: Use the heater to avoid
overheating.
It blows cool air for 10 seconds before it
starts to heat.
RESULT
1. Press once. The indicator light comes
on. The device turns on. All functions
are activated.
2. Press again. The flame effect is
switched off. Power and all functions
switched off.
1. Press once. The indicator light comes
on. The timer is set to 0.5 hours.
2. Press again until the desired setting is
set reached. The indicator lights show
the setting.
1. Press once. The flame effect becomes
weaker.
2. Press again until the desired setting is
reached.
1. Press once. Flame becomes lighter.
2. Press again until the desired setting is
reached.
1. Press once. The indicator lights up.
Fan blows cool air for 10 seconds.
Heating level switches on and blows
warm air.
2. Press again. The indicator lights up.
High heating level turns on and blows
hot air.
3. Press again. Heating switches off
The fan briefly blows cool air and then
switches off.
Low
54