Glow Fire Neptun Mode D'emploi page 50

Info
STEP 2:
A: Find the wall studs (uprights). Mark the drill holes with a pencil. The holes should be 8
"(20.3 cm) apart and height. The minimum height from the bottom surface must be
19.7" (50 cm).
B: Three screws should be screwed directly into the wall screws.
C: If there are only two bolts, two screws must be screwed together. Directly into the bolts,
and the other screws must be screwed into the drywall plugs.
STEP 3:
A: Drill a hole in each mark with a 1/4 "wood drill.
B: Carefully tap the drywall plug (C) into the drywall until it is flush with the drywall surface.
Be careful to avoid damage.
The wall fastening elements contained in this chimney are only to be
used for installation on drywall. For concrete walls or other wall types,
consult a specialist for the best fastening methods.
50