Technical Data - EINHELL TK1000 Mode D'emploi

Anleitung 12-spr. TK 1000
GB
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E DIN EN 31201;
6/93,ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be
introduced for the user (ear-muffs).
Sound pressure level LPA
Sound power level LWA
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
14
02.11.2001 10:00 Uhr
Cutting Idling
88 dB(A) 74 dB(A)
97 dB(A) 83 dB(A)
Seite 14

5. Technical data

Asynchronous motor
Power rating
Temporary operation
Idle speed n0
Carbide saw blade
Number of teeth
Table size
Cutting height max.
Height adjustment
Table tilt
Connector for dust extractor
Size, complete
Packaging
Weight
Intermittent periodic duty (S3) means that cooling
intervals (OFF periods) are necessary during
operation. The OFF period has to be long enough to
prevent the machine from overheating but does not
require the motor to cool to room temperature.
The ON period and the OFF period together add up
to the cycle duty time. According to the standard the
cycle duty time equals 10 minutes, i.e. a load factor
of S3 50% corresponds to an ON period of 5 minutes
and an OFF period of 5 minutes.
6. Before putting the machine into
operation
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong stand.
All the covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
Cation! Always pull out the power plug before
carrying out any maintenance or conversion
work.
230 V 50 Hz
1000 W
S3 40%
2800 rpm
200 x 30 x 2.5 mm
20
500 x 420 mm
43 mm / 90°
26 mm / 45°
infinite 0 - 43 mm
infinite 0 - 45°
dia. 35 mm
500 x 420 x 211 mm
512 x 444 x 290 mm
14 kg