Makita 4326 Manuel D'instruction page 7

OPERATION
CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
Advance the tool very slowly when cutting curves or
•
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
1
008087
Bevel cutting
008088
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
Raise the dust cover all the way before making
•
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
1. Cutting line
2. Base
2
008089
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel angle
by graduations. Then tighten the bolt to secure the base.
008090
Front flush cuts
008091
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
008092
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
7
1. Hex wrench
1
2. Bolt
2
3. Base
3
1. Edge
1
2. Graduation
2
1. Hex wrench
1
2. Bolt
2
3. Base
3
1. Starting hole
1