User Tips; Leg Installation; Filter Replacement - Vornado CYLO50 Guide De L'utilisateur

USER TIPS

1. Keep retail carton to store unit when not in use.
2. For best results, position the front of the unit (side with logo) towards
the center of the room, leaving at least a 6 inch distance away from
walls or furniture on every side.
6 in.
6 in.
Note: For optimum airflow, air outlet should be unobstructed. Ensure
curtains and other items are far enough away from the unit to not be
pulled into the side inlets or interfere with airflow.
10 English

LEG INSTALLATION

You will need to install the 4 legs onto your Air Purifier before use.
Note: DO NOT turn on unit without first installing the legs. Air
is being pulled in from underneath the unit. The motor could be
damaged if proper airflow is not given by installing the legs.
1. Turn unit upside down.
2. Line leg up with holes on bottom of unit.
3. Push leg firmly into unit until it snaps into place.
4. Install all 4 legs before turning unit right-side up.

FILTER REPLACEMENT

GENUINE VORNADO FILTERS ARE RECOMMENDED
Peak performance is only realized when genuine Vornado Carbon
and HEPA filters are used. Others may claim to be compatible with
Vornado units, but the Vornado Air Purifier is calibrated to achieve a
99.97% capture rate of particles 0.3 microns or larger, only when used
with Vornado Filters.
HOW TO REPLACE YOUR FILTERS
1. Turn off and unplug unit.
2. Turn over the unit and remove the Filter Frame by twisting the Filter
Frame Support Tabs to the open position.
TAB
TAB
TAB
3. Remove and discard used Filters. Simply take hold of the Pre-Filter
at any place along the perimeter and remove. To remove the Filter
Cartridge, pull upward on side tabs until filter is removed.
Note: Clean any remaining dust or hair inside the unit by using a
vacuum hose. Do Not use water or liquids to clean the unit.
4. Replace with genuine Vornado Filters. Place the Filter Cartridge
in the unit and gently press around the perimeter to ensure place-
ment. Carbon side of cartridge will go into the unit first so tabs on
Hepa are facing up. Place Pre-Filter on top of Hepa.
5. Place Filter Frame on top of Carbon and twist Filter Frame Support
tabs into the locking position.
6. Turn unit right-side up.
7. To reset the Filter Replacement Indicator, press and hold
approximately 3 seconds until Filter Replacement light has turned off.
Note: Do not operate the Air Purifier without a Vornado 3-in-1 Filter
Cartridge.
for
English 11