Cleaning And Maintenance; User Tips; Troubleshooting; Storage - Vornado AC300-EU Manuel D'utilisation

Cleaning and Maintenance

How to Clean
Because large volumes of air pass through your Vornado Air
Purifier each day, it will need regular cleaning.
1. Unplug the unit before cleaning.
Note: Do not use gasoline, thinners, solvents or other chemi-
cals for cleaning.
2. Wipe down with a soft, damp cloth. (Figure 1)
3. Dust or vacuum the interior and along the sides. It is recom-
mended to clean the interior when the filters are changed.
(Figure 2)
Fig. 1 Fig. 2
Other Maintenance
The motor is permanently lubricated so it needs no service. No
other serviceable parts, other than filters, are contained within the unit.
12 English

User Tips

1. Keep retail carton to store unit when not in use.
2. Use the hand holds on either side of the unit for easy carrying.
3. For best results, position the front of the unit (side with logo)
towards the center of the room, leaving at least a 15 cm.
distance away from walls or furniture on every side.
Note: For optimum airflow, air outlet should be unobstructed.
Ensure curtains and other items are far enough away from the
unit to not be pulled in side inlets or interfere with airflow.
15 cm
15 cm
Problem Possible Cause and Solution
Unit fails to power on. Unit is not plugged in. Plug power cord into electrical outlet.
Front Panel may not be properly installed. Remove and reinstall the Front Panel to assure proper placement.
Refer to FILTER REPLACEMENT.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse. For assistance, contact a licensed electrician.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Airflow is weak or slow. Unit set to a low speed setting. Adjust to a higher speed setting.
Debris build-up on filter. Check and replace filters.
Airflow is blocked. Remove obstruction.

Storage

Follow the steps below when you are ready to store your unit.
1. Unplug power cord and bundle loosely.
2. Lift unit with both hands, using hand holds. Refer to
USER TIPS.

Troubleshooting

3. Cover, or place back in retail carton if available. This will
prevent the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
English
13